Here is a short list of what I am missing.
- Metric stainless steel hex headed screws, I ordered an assortment of m2, m3 and m4 + lock nuts from (microfasteners)
- Epoxy resin (LF 285 with 90min hardener) (http://www.swiss-composite.ch)
- 1 meter of CF ribbon, 10mm wide (http://www.swiss-composite.ch)
- Cotton flakes to mix with the resin when "glueing" engine mounts and servo mount etc.. (microballons should do as well) (http://www.swiss-composite.ch)
- Some small paint brushes and mixing sticks
- Black sikaflex marine silicone
- Loctite 648 for glueing the flexicable to the outdrive shafts
- 2 mm CF plate for making the backboard re-enforcement where the arneson drives mount
- 4mm and 5mm stainless steel tubing with thin walls
- 8mm brass tubing and 7mm teflon tubing for the flexicable stuff tubes.
- 4.75mm flexicable
- Motors + watercooling jackets, ESC's, 6mm connectors and motor hubs
- Water cooling intakes which will be modified with stainless tubes
Posts
No comments:
Post a Comment