Drive installation complete and more

OK, so I have finished pretty much everything for the drives. Shafts are now glued in place as well as the shaft support's, motor side. I also glued in the servo mount for the rudder.



Below you can also see the battery mounts which I cnc'd to make room for some straps and access ports to get underneath them.



Now I have started looking at how I am going to layout everything in the hull to get a correct CG with the possibility to move the CG point forward and aft by about 2cm.
Will look something like this though missing from the shot is the Rx and the Rx battery which will be placed fore of the servo mount which is prefect since this will add some weight behind the CG point and allow me to move the big Lipo's forward.